Home About UsCategoriesCatalog DownloadLogisticsFinancingOnline ShowNewsContact Us

Pliers, Hammers, Screwdrivers, Pipe Wrenches

Home > News

A Caulking gun is a tool to hold a tube or box filled with the material used to seal gaps and faults in a home.

How to Use the Glue Gun?

Nov. 06 , 2020

Caulking GunA Caulking gun is a tool to hold a tube or box filled with the material used to seal gaps and faults in a home. Caulking materials can be made of silicone or latex and are used to bond various materials such as metals, glass, wood, and ceramics. The caulking material is usually placed in the pipe. You will need a caulking gun to remove the caulking agent from the tube. The gun not only helps you adjust how many caulks are released at a time but also makes the caulks appear exactly where you want them to.

The main points for attention when selecting a glue gun

Check the lever.

Squeeze the manual trigger with the manual caulking gun and push a lever into the back of the caulking agent tube, which in turn pushes the caulking agent out of the tip of the tube. There are two main types of guns with slightly different performance.

Ratchet: A seamed gun with a ratchet rod (a sawtooth rod that is "caught" in each hand) is inexpensive and suitable for light duty. The biggest problem with the ratchet rod is that the sealant seeps until you twist the end of the rod and pull it back to release pressure. This can cause confusion and lead to a waste of sealant.

Smooth slider: After applying the sealant with a smooth slider caulking gun (often advertised as "drip-free"), press the thumb lever to release the pressure on the sealant.

The application method of China Caulking Gun.

Use your thumb to press the release on the back of the gun and release the plunger on the back.

Fully pull back the plunger. Place the pipe into the spray gun with the nozzle in front.

Push the plunger firmly into the back of the tube and remove the thumb. The gun is loaded.

Cut the tip of the cartridge to match the size of the gap to be filled.

Drive a nail or tack through the hole to Pierce any internal seal.

Hold the gun at a 45-degree Angle along the gap to be sealed.

Squeeze the handle of the gun or trigger it slowly while pulling the gun towards you. When you can no longer squeeze the handle, release it. It will automatically bounce back. When it is in its original position, you can squeeze again. How hard you squeeze the trigger and how fast you move the gun will determine how much caulking is applied to each position. Keep in mind that there are more gaps at the end of each squeeze.

When finished, you can smooth out the gap with your finger.



Contact Us




Recommend Products: test

Copyright © Sinotools Industrial All rights reserved. Technical Support: